Airtame 3 Safety Manual hero section desktop background

Airtame 3 (AT-DG3)
Safety Manual

Revision A – 28/11/2025

Safety precautions

The Airtame 3 has been designed with high attention to the safety of the user. However, if used improperly, the Airtame 3 can potentially cause fire, electrical shock or personal injury.

To avoid any accidents, please pay attention to these guidelines:

Do not use the Airtame 3 outdoors.
Do not place the Airtame 3 in direct sunlight.
Do not expose the Airtame 3 to water or extreme conditions (moisture, heat, cold, dust) as it could potentially damage it or cause it to malfunction.
Stop the use of the Airtame 3 immediately if it
- (i) functions in an abnormal manner,
- (ii) produces unusual sounds,
- or (iii) produces unusual odors.
Do not attempt to disassemble or repair the Airtame 3 yourself. Doing so voids the limited warranty and could harm you, your screen/projector, and/or the Airtame 3.
The Airtame 3 generates heat during use resulting in a temperature increase on the surface as it conducts the heat away. Handle with caution as the surface may feel hot to the touch. If you wish to remove it, unplug the Airtame 3 from the power source and let it cool down before touching it.
Do not mount the Airtame 3 on a hot surface, near a ventilation or hot air exhaust as this can increase its temperature drastically and cause it to malfunction or shut down.
The adhesive strips may leave marks or detach from the wall.
Glue on adhesive strips hardens to 50% strength after 20 minutes, and to 100% after 24 hours.
The glue on adhesive strips bonds best to metals and plastics, such as acrylics, polycarbonate, and ABS.
The recommended ambient operating temperature of the Airtame 3 is: 0 to 40 °C (32 to 104 °F).
Operating altitude up to 3000 meters.
The recommended Operating Humidity is 20-90%RH non-condensing.
WARNING: Choking hazard. Some Airtame 3 accessories should be kept away from small children as they may present a choking hazard.
This product is intended to be used with a Listed Power Adapter or DC power source marked “L.P.S” (or “Limited Power Source”), rated 12Vdc, 30W, or a 42.5~57 Vdc, min 30W Gigabit Passive PoE injector, IEEE 802.3at, Tma=40 degree C.

Legal notices

Model: AT-DG3
Contains FCC ID: 2ADEFAT-DG3
Contains IC: 12460A-ATDG3

Legal entities

Airtame ApS
Langebrogade 6B, 2nd floor
1411 Copenhagen, Denmark

Airtame US, Inc
228 Park Ave S
New York, NY 10003
United States

License agreement and general terms

The use of any software related to Airtame 3 or any products by Airtame ApS / Airtame US, Inc are governed by the Terms of Service and End User License Agreement which can be found at airtame.com/legal/.

When using the Airtame 3 or any products of Airtame ApS / Airtame US, Inc you acknowledge and accept those terms.

Warranty information

Please check warranty information at airtame.com/legal/.

Federal Communications Commission (FCC) Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

United States Wireless Radio Use

This device is restricted to indoor use when operating in the 5.15 to 5.25 GHz frequency band.
To comply with US FCC regulation, the country selection function has been completely removed from all US models.
The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user.

FCC Radiation Exposure Statement

To satisfy FCC and IC exposure requirements, a separation distance of at least 20 cm (8 inches) should be maintained between the antenna of this device and persons during device operation. Operations at closer than this distance are not recommended.
The antenna used for this transmitter must not be co-located in conjunction with any other antenna or transmitter.

Industry Canada (IC) Notices

English:
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the Equivalent Isotropically Radiated Power (EIRP) is not more than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

French:
Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie.

Canada
Dans le but de réduire les risques de brouillage radioélectrique à l’intention des autres utilisateurs, il faut choisir le type d’antenne et son gain de sorte que la Puissance Isotrope Rayonnée Équivalente (PIRE) ne dépasse pas l’intensité nécessaire à l’établissement d’une communication satisfaisante.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage,
et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
IC Radiation Exposure Statement
Cet appareil est conforme aux limites d’exposition aux rayonnements de la IC CNR-102 définies pour un environnement non contrôlé. Afin d’éviter la possibilité de dépasser les limites d’exposition aux fréquences radio de la IC CNR-102, la proximité humaine à l’antenne ne doit pas être inférieure à 20cm (8 pouces) pendant le fonctionnement normal.

Wireless Radio Use
Cet appareil est restreint à usage en intérieur pour la bande de fréquence 5.15-5.25 Ghz.

European Union Compliance

Airtame ApS declares that this equipment is in compliance with the essential requirements and other provisions of Directive 2014/53/EU. The full Declaration of Conformity can be found at airtame.com/compliance.

European Union Wireless Radio Use

This device is restricted to indoor use when operating in the 5.15 to 5.35 GHz frequency band in the following countries: Belgium, Bulgaria, Czech Republic, Denmark, Germany, Estonia, Ireland, Greece, Spain, France, Croatia, Italy, Cyprus, Latvia, Lithuania, Luxembourg, Hungary, Malta, Netherlands, Austria, Poland, Portugal, Romania, Slovenia, Slovakia, Finland, Sweden, Norway, Iceland, Lichtenstein, Switzerland, North Ireland and Turkey.

Maximum EQUIVALENT ISOTROPICALLY RADIATED POWER:
Bluetooth—2400-2483.5 MHz: 20 dBm EIRP
Wi-Fi—2400-2483.5 MHz: 20 dBm EIRP
Wi-Fi—5150-5350 MHz: 23 dBm EIRP
Wi-Fi—5470-5725 MHz: 23 dBm EIRP
Wi-Fi—5725-5875 MHz: 13.98 dBm EIRP

RF Exposure Information Statement

This device has been tested and meets applicable limits for Radio Frequency (RF) exposure. This equipment should be installed and operated to ensure a minimum of 20 cm spacing to any person at all times.

Waste management

Waste management of Airtame follows the WEEE Directive 2012/19/EU and the RoHS recast Directive 2011/65/EU. More information can be found at airtame.com/compliance.

Airtame 3 is designed by Airtame ApS / Airtame Inc www.airtame.com

FCC: Federal Communications Commision
CE: Conformité Européenne
RCM: Regulatory Compliance Mark
WEEE: Waste Electrical and Electronic Equipment Directive
Warning: Please refer to the Knowledge Center for further instructions.
CAN ICS- 3 (B)/NMB-3(B)

Airtame 3 (AT-DG3)Safety Manual

Contents: